I finally have had a couple of days to work on the boat. Man I have missed it so much!!!
I left off with beadboard installed to just past the galley (kitchen). So my project (other than friggin tarp repair, see previous post) has been to continue into the Stateroom (bedroom).

So here are some pictures as I make my way around the room. Please note the cubby holes below the window. There is a plywood shelf that runs the length of the hull that acts to stiffen the hull and it also was where the original wiring and control cables laid. To my way of thinking it was a lot of wasted space so I am going to construct some boxes which will insert into the openings to give us additional storage.





Here's the rear bulkhead and port side with nailer's and insulation in place. I am going to insulate the rear bulkhead on the engine room side since the windows are right to the edge.



We are going to go with two beds. One on each wall with an aisle down the center. I am going to make platforms with drawers underneath for more storage. Here's a rough idea of the placement.



That's it for now. I'll try to get some more done soon.

Hang to the riggins,
Wado